Digital Voltage Selection Control for L200 Regulator

Posted on February 5, 2010 by Adam

This is digital voltage selection control circuit. This circuit uses L200 Regulator. It can be used to regulated the output voltage digitally. Here is the circuit :
Digital Voltage Selection Control for L200 Regulator1 circuit schematic diagram

A combination of P2, R3, R2, and R1 with R5 form voltage divider that determine the output voltage.  The transistor is used to switched off this circuit. The output voltage does not exceed 0.45 V and pin 2 is brought to ground potential, when the inhibit transistor is saturated. [Source: STMicroelectronics Application Note]

This entry was posted in Power Supply and tagged . Bookmark the permalink.,

Possibly Related to "Digital Voltage Selection Control for L200 Regulator" Circuits

  • Higher Input Or Output for L200 Voltage Regulator
    This is higher input or output for L200 voltage regulator circuit. This circuit is designed to solve the problem that occurs when the input or output voltages are higher than the device can produce. This circuit uses the external components. … Continue reading →...
  • Low-Dropout (LDO) Voltage Regulator
    This is a Low-dropout (LDO) Regulator circuit, constructed by using only a single PNP transistor. This circuit is directly related to load current. At very low values of load current as little as 50 mV. This circuit has maximum specified … Continue reading →...
  • Programmable Current and Voltage Regulator for Battery Charger
    This is a programmable current and voltage regulator circuit. It consist of a voltage regulator with external current limitation. The variable resistor R2 is forced by a constant current because of the fixed voltage of 2.77 V at the terminals … Continue reading →...
  • Power Control: Synchronization by The Mains Voltage
    On the circuit diagram below show us a schematic of step-down circuit which is used to approximately divide by two the rms voltage between the line input and the inductive load (L1). C2 and R3 give a turn-on delay of … Continue reading →...
  • Switch Mode Regulator Provides -12V Negative Supply from Positive Supply
    This is a circuit that can provide -12 V negative supply from positive supply. The output voltage is Vo= -Vin· D/(1-D). The maximum output current is Iout=1·(1-D). Here is the circuit : In this circuit, the ground of U1 is … Continue reading →...

Comments are closed.