Very Simple Lead Acid Battery Charger with PB137 Regulator

This is a Very Simple circuit for Lead Acid Battery Charger using PB137 Regulator. The PB137 is used for lead acid battery charger circuit because it can give 1.5A at Vo=13.7V. The PB137 also has a reverse leakage current. The maximum reverse leakage current of PB137 is 10µA at Tj=0 to 40°C and V1=floating and Vo=13.7V. Here is the circuit :

Simple Lead Acid Battery Charger with PB137 Regulator circuit schematic diagram

The PB137 has many feature, such as it has internal current limiting, safe area protection, and thermal shutdown. So, it is indestructible. The PB137 also can send over 1A output current if adequate heat-sinking is available. [Source: STMicroelectronic Application Note]

This entry was posted in Power Supply and tagged . Bookmark the permalink.,
Possibly Related to "Very Simple Lead Acid Battery Charger with PB137 Regulator" Circuits

  • BQ24105 Switch Mode Lead Acid Battery Charger
    Switch mode circuits can implement the lead acid battery charger with a more efficient. It can be constructed using bq24105 battery charger controller. The bq24105 was originally designed to charge single-, two- or three-cell Li-polymer and Li-ion  battery packs. The … Continue reading →...
  • Sealed-Lead Acid Battery Charger
    To optimally control the charge and hold cycle for sealed lead acid battery, UC2906 series of battery charger controllers is used by all of the necessary circuitry. These integrated circuits control and monitor both the output voltage and current of … Continue reading →...
  • Lead Acid Battery Charger Circuit
    To charge lead-acid batteries we can use this circuit that consist of a current-limited power supply and a flyback converter topology. Here is the schematic diagram of the circuit : Isolation and voltage input range flexibility are provided by the … Continue reading →...
  • Two Transistors Lead Acid Battery Monitor
    The circuit of battery monitor below uses 3 separate LEDs. Voltage level between 6v to below 11v will turn the red LED on and will turn off above 11v. Between 11v and 13v will turn the orange LED on and … Continue reading →...
  • Single Transistor Lead Acid Battery Monitor
    Using a dual-colour LED and few surrounding components, we can make a very simple battery monitor. This battery monitor circuit is suitable for  monitoring your car battery, enrich your dashboard with cool and functional accessory. Orange colour is produced by … Continue reading →...

Comments are closed.