Single Chip Two-Tones Siren

Kids like the police or fire-brigade cars siren sound. This circuit can generate dual tone like Police or Fire-brigade cars siren sound. This circuit usually installed on battery powered cars, bicycles, and motorcycles. Not only that, but also can be installed in models and other games. Here is the schematic diagram of the circuit:

One IC two tones Siren circuit schematic diagram

Basically, this circuit utilize the IC1A and IC1B gates oscillation to reproduce the typical dual sound of Fire-brigade or police cars. When the P1 is pressed, the IC1C and IC1D start oscillate, the old siren sound increasing and slowly decreasing in frequency is regenerated. The output sound is produced by the loudspeaker. The period and tone of the sound oscillations depends on the value of C5, C2, C6, C1 and/or associated resistors. This circuit does not have power switch. [Circuit’s schematic diagram source: english.cxem.net]

This entry was posted in Audio and Music and tagged . Bookmark the permalink.,
Possibly Related to "Single Chip Two-Tones Siren" Circuits

  • Dual Tone Single IC Siren
    This circuit is a double tone Police sound and Single tone old ambulance sound. This circuit is usually installed on a on battery powered cars, motorcycles, and bicycles for fun kid not only that, this circuit also used in  models … Continue reading →...
  • Wailing Alarm Siren
    This alarm siren circuit give continuous frequency sweep, a warbling sound. The warbling period is about 6 seconds, 3 seconds for frequency sweeping up and 3 seconds for frequency sweeping down. You can change the warbling frequency of this alarm … Continue reading →...
  • Two Tones (Ambulance) Alarm Circuit
    Using very popular multivibrator 555 IC, we can build an alarm circuit which is similar to old ambulance siren. There are two sections inside the circuit, first is a low frequency oscillator for two level frequency modulation, and the second … Continue reading →...
  • Ambulance (Hee-Haw) Siren
    The circuit below consists of two multivibrators. The first multivibrator provides the speed of the change from “hee” to “haw” and operates at a low frequency. By allowing full voltage to appear at the bottom of the 220R and then … Continue reading →...
  • Single Chip FM Transmitter, For Short Range Application
    The FM transmitter circuit here works in the broadcast band 88 to 108MHz, and can be used to broadcast audio signals for remote listening.  The output power is around -21dBm, and the circuit operates with 3V power supply. Here is … Continue reading →...

Comments are closed.