Relay Driver with Strobe

LM111 comparator can be used o design a relay driver with TTL strobe, this can be used to provide more control of your relay driver. You can control the strobe input using a microcontroller or otherĀ  digital signal. Here is the schematic diagram of the relay driver:

Relay Driver with Strobe circuit schematic diagram

[Source: National Semiconductor Application Note]

This entry was posted in Control Electronics and tagged . Bookmark the permalink.,
Possibly Related to "Relay Driver with Strobe" Circuits

Warning: ksort() expects parameter 1 to be array, object given in /home/simpleci/public_html/wp-content/plugins/yet-another-related-posts-plugin/includes.php on line 395

  • Precision Photodiode Comparator
    This photodiode signal conditioning circuit is sensitive to light signal, suitable for interfacing digital serial signal. The biasing of the LM111 noninverting input is matched to the diode’s dark output, so it should be very sensitive. [Source: National Semiconductor Application … Continue reading →...
  • Driving Relay with 555 IC
    This is a Driving Relay circuit using 555 IC. The circuit is used to drive a relay to avoid 555 hangs up, it uses an inductive feedback. The coil is prevented to drive Pin 3 below a negative 0.6V by … Continue reading →...
  • 100 kHz Free Running Multivibrator
    This free running oscillator employs LM111 comparator. The output of this oscillator is square wave. You can use this square wave oscillator for general purpose. Here is the schematic diagram of the circuit: [Source: National Semiconductor Application Note]...
  • Digital Transmission Isolator
    Digital transmission isolation is important for keeping the digital noise to reach the analog path, that’s the benefit for noise isolation. For electrical isolation, isolating the signal after digitizing is often easier since digital signal is inherently nonlinear, no need … Continue reading →...
  • JFET Nixie Tube Driver
    This is a driver circuit for nixie tube. This circuit uses 2N3684 as nixie tube drivers because its Vp is 2-5 volts which is ideally matches TTL-DTL logic level. Compared with bipolar transistor, the JFET is immune to almost all … Continue reading →...

Comments are closed.