How To Use A Multimeter – Video Tutorial

This is a video tutorial about multimeter. This video shows how to use a multimeter. The multimeter can be used to measure voltage, current, resistance, etc. The multimeter that is used in this video is a digital multimeter. First thing that must be done before use the multimeter is calibrate the multimeter by connecting each probe. In this video, the multimeter is used to verify the connection in the board. And also, it used to measured resistance of resistor. Here is the video :

This entry was posted in Video Tutorial. Bookmark the permalink.,
Possibly Related to "How To Use A Multimeter – Video Tutorial" Circuits


Warning: ksort() expects parameter 1 to be array, object given in /home/simpleci/public_html/wp-content/plugins/yet-another-related-posts-plugin/includes.php on line 395

  • How to Use a Clamp Meter : Testing Current on an Appliance – Video Tutorial
    This is a how to use a clamp meter video tutorial. This video shows the example of use of clamp meter. Clamp meter is a tool that can measure the current without connecting on the wire. So we can measure … Continue reading →...
  • Potentiometers – Video Tutorial
    This is a video tutorial about potentiometer. This video talks about a potentiometer and how it works. Potentiometer is a resistor that its resistance can be varied. The values shown on the potentiometer is the maximum resistance that can be … Continue reading →...
  • How to Use a Volt-Ohm Meter Safely – Video Tutorial
    This is a video tutorial about how to use a volt-ohm meter safely. This video describes about properly use and safety use a voltage meter. First, we must make sure the voltage meter is set up to volts. The black … Continue reading →...
  • Digital pH Meter Signal Conditioner
    A pH meter circuit is basically an amplifier to boost a voltage signal which is produced by a pH probe. The pH probe itself is equal to a battery cell when submersed in the measured solution, producing a weak voltage … Continue reading →...
  • Digital pH Meter Signal Conditioner with Pulse/Frequency Output
    A signal conditioner for pH meter probe is required to have high input impedance. The signal conditioning of the pH meter probe is done by providing a buffer with gain, offset, and volatge to frequency converter. High input impedance requirement … Continue reading →...

Comments are closed.