2.5KV Isolated RS232-TTL/CMOS Converter/Driver/Receiver

The ADM3251E is a transceiver which has a high speed, 2.5 kV fully isolated, single channel RS-232/V.28. This device is operates from a single 5 V power supply. The device is ideally suited for operation in electrically harsh environments or where RS-232 cables are frequently being plugged and unplugged due to the high ESD protection on the RIN and TOUT pins.

2.5KV Isolated RS232 TTL CMOS Converter Driver Receiver circuit schematic diagram

The ADM3251E incorporates dual-channel digital isolators with isoPower™ integrated, isolated power. To use a separate isolated dc-to-dc converter needn’t a requirement. Both is used by Chip-scale trans-former iCoupler® technology from Analog Devices, Inc. for the isolation of the logic signals as well as for the integrated dc-to-dc converter. A total isolation solution is the result.

The ADM3251E contains isoPower technology. This technology uses high frequency switching elements to transfer power through the transformer. During printed circuit board (PCB) layout, we have to do special care to meet emissions standards. For details on board layout considerations, Refer to Application Note AN-0971, Control of Radiated Emissions with isoPower Devices. [Circuit’s schematic diagram source: Analog Devices]

This entry was posted in Control Electronics, Test and Measurement and tagged , . Bookmark the permalink.,
Possibly Related to "2.5KV Isolated RS232-TTL/CMOS Converter/Driver/Receiver" Circuits

  • Isolated 15 to 1000V DC-DC Converter
    The circuit shown in the schematic diagram below is an isolated dc-to-dc step up converter. Being isolated means that there is no electrical connection between the input and the output. We can say that there will be no current or … Continue reading →...
  • RS232 Line To 5 V Level Converter
    RS 232 line to 5 V converter circuit schematic diagram is shown on the following figure. The MAX680 is normally used as a charge pump voltage converter. This converter can convert +5 V to ±10V. The MAX 680 works in … Continue reading →...
  • MAX1703 Single-Cell Boost Converter Circuit
    When you design a circuit with only a single-cell battery, you will need boost-converter to provide enough voltage for most application. This circuit is a modification of the diode-OR connection circuit. The linear regulator is formed by the U1’s internal … Continue reading →...
  • Isolated Remote Temperature To Frequency Converter
    The following circuit shown in the schematic diagram converts temperature reading (from +30° to +30° F) to its corresponding frequency (30 to 3000 Hz). Other benefit is that a 4N28 isolate the output to protect the receiver from dangerous interference. … Continue reading →...
  • Transformerless Dc -To- Symmetric DC Converter
    A DC to DC converter is needed for a board that only has +5V supply but have to provide dual-polarity supplies for few device such as op-amp or some DAC. Using switched capacitors as the main converting element (diode-capacitor voltage-doubler), … Continue reading →...

Comments are closed.