Low Voltage Power Supply

This is a power supply circuit that produce voltage 12 to 24 V.  It is very simple, doesn’t need regulator just bridge rectifier, filter capacitor and transformer. A bridge rectifier makes use of four diodes in a bridge arrangement to achieve full-wave rectification. This circuit will give you 15 VDC at up to 3A.

To prevent damage to circuit or blowing that during testing, you should use a 10 ohm 25W resistor to limit the current.

Here is the schematic diagram of the circuit:

lowjadi circuit schematic diagram

This entry was posted in Power Supply and tagged . Bookmark the permalink.,
Possibly Related to "Low Voltage Power Supply" Circuits

  • Low-Cost AC Supply
    Applying the filtered and rectified AC input to a high-input-voltage linear regulator is the simplest way to produce low current level from an AC source. However, it will causes the power dissipation in the regulator. The power dissipation can be … Continue reading →...
  • Linear Power Supply
    A diode bridge, a step down transformer a linear regulator(U1) and some filtering capacitors can be used to build a Linear power supply. This circuit has some advantages such as this circuit has high output current and can give multiple … Continue reading →...
  • Crowbar Power Supply Overvoltage Fault Protector
    This is a The Crowbar circuit. This circuit is used to prevent the load from damaging. This circuit utilize a zener diode. The regulator steps down the 12V input to 5V. The load will damage when the regulator is fail … Continue reading →...
  • Compact Power Factor Controller
    This is compact power factor controller circuit. It stabilizes device’s electrical demand to give best power factor characteristic of many types of loads. In many application, a direct rectification of the AC line followed by bulk capacitor filtering is used … Continue reading →...
  • Constant Current Constant Voltage Switching Power Supply
    This is a circuit that produces constant current constant voltage  SMPS. To efficiently charge a battery, we can use constant current constant voltage  SMPS. This circuit produces 600 mA at constant current mode and 7.2V at constant voltage mode. Here … Continue reading →...

Comments are closed.