Contactless Live Line Detector

Live-line detector is a circuit that detects the presence of a live mains conductor circuit operation: capacitive coupling between the live conductor and the probe will clock the counter when this unit was around a live conductor. And then the counter causes the LED to flash 5 times per second.  It can occur due to the 4017 IC divides the mains 50Hz frequency by 10. This unit will stop counting, when remote from a live and then the LED resulting permanently off.

contactless live line detector circuit schematic diagram

Notes: Length sensing probe can affect the sensitivity. The LED’s current limiting resistor can be omitted, because it’s a 3V operation [Source: electronics-lab.com]

This entry was posted in Power Supply, Test and Measurement and tagged . Bookmark the permalink.,
Possibly Related to "Contactless Live Line Detector" Circuits

  • CD4093 Water Level Sensor (Detector)
    This water level sensor (detector) circuit uses a standard NAND logic gate to produce oscillation and to detect the water level. Oscillation is included inside this circuit to provide alternating current (AC) source for probe electrodes, to achieve a corrosion … Continue reading →...
  • Water Level Sensor/Detector/Monitor With Alarm
    This schematic diagram shows a water level sensor/detector/monitor circuit. An alarm is also featured in this circuit. Any fluid with a resistance under 900K between the maximum separation distance of the probes will trigger this circuit. A 4050B CMOS hex … Continue reading →...
  • A Ph Probe Buffer Amplifier
    Buffer amplifier is required by a typical pH probe to isolate its 10^6 to 10^9 ohm source resistance from external circuitry. Such an amplifier is shown in the following figure. The voltage error produced by the bias current and electrode … Continue reading →...
  • Temperature Probe for Digital Multi Meter
    This is a simple temperature measurement probe circuit. This circuit measures temperature either on a PC board or at the probe tip to which contains the temperature sensor. It can be used for debugging and troubleshooting electronic circuits. Here is … Continue reading →...
  • High DC Voltage Current Sensing
    LTC6101 op-amp can be used to build High voltage current monitoring/sensing. This circuit can senses current in 500 volts system. Here is the schematic diagram of the circuit: To hold off the voltage, two external Mosfets is added to the … Continue reading →...

Comments are closed.