FETVM-FET Voltmeter

This is a circuit of FETVM-FET Volmeter. The function of the VTVM is replaced by the FTEVM while at the same time ridding the usual line cord instrument. This circuit can allow a 0.5 volt scale range because drift rate of FETVM are superior to vacuum tube circuits. Here is the circuit:

FETVM FET Voltmeter circuit schematic diagram

The 2N4340 are implemented on this circuit because it has low noise and low leakage. [Source: National Semiconductor Application Notes]

This entry was posted in Test and Measurement and tagged . Bookmark the permalink.,
Possibly Related to "FETVM-FET Voltmeter" Circuits

  • JFET Nixie Tube Driver
    This is a driver circuit for nixie tube. This circuit uses 2N3684 as nixie tube drivers because its Vp is 2-5 volts which is ideally matches TTL-DTL logic level. Compared with bipolar transistor, the JFET is immune to almost all … Continue reading →...
  • Low Noise Power Supply for Audio Circuits
    This low noise audio power supply circuit can reduces noise and ripple voltage by 40dB over the 100Hz to 20kHz audio range. In portable application such as cellular phones and multimedia notebook computers, a clean source of 5V power for … Continue reading →...
  • Sample and Hold With Offset Adjustment
    This is a simple sample and hold with offset adjustment circuit. Sample and hold circuit is used to operate on analog information in a time frame which is expedient. This circuit works by sampling a segment of the information and … Continue reading →...
  • Broadband Noise Generator
    To test some electronic systems such as RF communication, filter, or audio we often need random noise source. This article shows the circuit that generates an RMS amplitude regulated noise source with selectable bandwidth. This circuit is suitable for wide … Continue reading →...
  • Crystal Oscillator
    Crystal oscillator, especially the low frequency one, can be easily implemented using op-amp as the amplifier. Here is the schematic diagram of such circuit: [Source: National Semiconductor Application Note]...

Comments are closed.