Oscilloscope-Triggered Sweep using 555 IC

We can use the 555 timer to hold the cost down of adding a triggered sweep to an economy oscilloscope. The timer is triggered by the circuit’s input op amp, adjusting its flip-flop and cutting off its discharge transistor so that capacitor C can charge. The flip-flop resets and the transistor conducts when capacitor voltage reaches the timer’s control voltage (0.33Vcc), discharging the capacitor. By substituting a constant-current source for the frequency adjust resistor (R), we can achieve greater linearity. Here’s the circuit diagram:

Oscilloscope Triggered Sweep circuit schematic diagram

[Source: Philips Semiconductors Application Note]

This entry was posted in Oscillators, Test and Measurement and tagged . Bookmark the permalink.,
Possibly Related to "Oscilloscope-Triggered Sweep using 555 IC" Circuits

  • Discrete R/S Flip Flop
    This circuit is an example of a set/reset flip flop. Set/reset flip flop is the simplest flip flop. This circuit using discrete components. Here is the schematic diagram : When this circuit obtain the power, only one of the transistors … Continue reading →...
  • 567 IC Oscillator With Double Frequency Out
    Sometimes, a precise two different frequencies are needed in synchronized circuit design, oneĀ  with certain frequency and another with exactly double frequency. Usually we build two clock signals with frequency with 1:2 frequencies by feeding an oscillator into a binary … Continue reading →...
  • Starting Network for Astable Multivibrator
    A flip-flop that generates two unstable states (high-low) is called astable multivibrator, a fancy name for you to say it’s an oscillator. The very basic of such circuit consist of two transistor where the collector of each transistor is wired … Continue reading →...
  • Car Tachometer with 555 IC
    Pulses are received by the timer from the distributor points. When the timer output is high, Meter M receives a calibrated current through R6. The meter don’t receives any current for that part of the duty cycle after time-out. A … Continue reading →...
  • ON/OFF Power Control with Single Pushbutton
    Today, simplicity and minimum controls is required for design of a handheld device. It will be very useful if a circuit allow us to turn the power on or of with a single push button. A single-pushbutton power control circuit … Continue reading →...

Comments are closed.