Audible Transistor Tester

All types of transistors including Darlington and power will be tested in this project. Connect the 9v battery around the other way at points A and B to test PNP types.

TRANSISTOR TESTER 1 circuit schematic diagram

The transformer in the photo is a 10mH choke with 150 turns of 0.01mm wire wound over the 10mH winding. Then, the two original pins (with red and black leads) go to the primary winding and the fine wires are called the Sec. Connect the transformer either way in the circuit and reverse either the primary or secondary (but not both) if it does not work. Almost any audio transformer will work any speaker will be suitable. [Source: talkingelectronics.com]

This entry was posted in Test and Measurement and tagged . Bookmark the permalink.,
Possibly Related to "Audible Transistor Tester" Circuits

  • Transistor Tester
    We can use this basically a high gain amplifier with feedback circuit to cause the LED flash at rate determined by the 10u and 330k resistor. Before insert the unknown transistor, remove one of the transistor. The LED flash when … Continue reading →...
  • Electronic Ear
    Circuit below is a very sensitive 3-transistor amplifier using a speaker transformer. This can be wound on a short length of ferrite rod as show above or 150 turns on a 10mH choke. The biasing of the middle transistor is … Continue reading →...
  • Good/Bad Transistor Tester
    Good/Bad transistor tester means that this instrument can only determine if the transistor is good or bad, nothing more. Any transistor with gain equal to 30 or more will be considered as good by this tester, and otherwise will be … Continue reading →...
  • 12V 40Watts (2x20Watts) Fluorescent Tube Lamp Inverter
    A 40 watt fluorescent (tube lamp, TL) or two 20-watt tubes in series will be driven by this circuit. The transformer is wound on a ferrite rod 10mm dia and 8cm long. The diameters of the wire are not critical … Continue reading →...
  • Passive Audio Stereo-to-Surround Adapter
    Below is a passive surround converter/adapter circuit diagram. To make this circuit works, passive surround doesn’t required any active components. This circuit only need the combined of resistors and electrolytic capacitors. Do not use woofer or tweeter speakers for rear … Continue reading →...

Comments are closed.