Oscillator With Quadrature Output Using 567 IC

Oscillator circuit is an electronic circuit that produce a periodic signal. The term quadrature refers to a fourth (1/4) phase shift of full wave cycle (1/4 of 360′ = 90′). In square wave oscillator, a quadrature simply means a 1/4 period phase shift. Here is a schematic diagram of such circuit:

Oscillator With Quadrature Output circuit schematic diagram

This circuit uses a 567 tone decoder circuit, which is  capable of generating an oscillation as well as detecting/decoding a frequency/tone. The component values calculation to get certain frequency operation is similar to general 567 IC based oscillator, f = 1/(1.1xR1xC1) [Circuit’s schematic diagram source: Philips Semiconductors Application Notes]

This entry was posted in Oscillators and tagged . Bookmark the permalink.,
Possibly Related to "Oscillator With Quadrature Output Using 567 IC" Circuits

  • Quadrature Sinewave Oscillator
    Quadrature oscillator is another type of phase shift oscillator. This circuit produce two sine wave signal. One of them is shifted 90 degree from the other signal. The output that shifted 90 degree is called cosine signal and the other … Continue reading →...
  • Bubba Oscillator
    One example of the  phase shift oscillator is Bubba oscillator. This oscillator gets 45 degree phase shift for each section from quad op-amp package. The result is excellent d(phase)/d(t) to obtain very low frequency drift. The circuit is shown below: … Continue reading →...
  • Square Wave Oscillator using Comparator/Op-Amp
    The circuit shown in this schematic diagram is a square-wave oscillator circuit.  The main component of this oscillator circuit is LP165/365 comparator. As timing component, it uses capacitor and resistor to determine the frequency operation, generating square waves signal. Here … Continue reading →...
  • Basic Phase Shift Oscillator 1KHz
    Phase shift oscillators uses capacitors to shift the phase of a signal coming from the output of an amplifier. If the phase shifting match the frequency, then a positive feedback will be produced a continuous sine waveform. Here is the … Continue reading →...
  • Precision Oscillator With 20ns Switching
    Precision oscillator can be built using quartz crystal, but with proper component selection, you can also build one with RC  (resistor and capacitor) circuit. Not only to build a tone/frequency decoder, 567  IC can be used to build such oscillator … Continue reading →...

Comments are closed.