220V Touch Switch

This is a 220V Touch Switch circuit. This circuit is used as switch which turn off and turn on the the electronic device that is connected to the 220V home electrical installations. Here is the schematic diagram of the circuit:

220V Touch Switch circuit diagram circuit schematic diagram

The electronic device that will be controlled should be connected to points symbolized with “LOAD”. To use this circuit, connect the circuit to the a 220V home electrical installations directly. This is a high current and voltage, so be careful and use adequate safety devices before doing the experiment.

WARNING: Make sure the 2.2MΩ resistor has no leakage, or a hazardous shock will hit you. [Circuit’s schematic diagram source: circuitdiagram.net]

This entry was posted in Control Electronics, Power Supply and tagged , . Bookmark the permalink.,
Possibly Related to "220V Touch Switch" Circuits

  • Separate ON-OFF Touch Switch
    Providing a touch switch can be a cool way to make your circuit looks sophisticated. Moreover, providing separate touch pad for “on” and “off” function improve the safety, since touching one function doesn’t trigger opposite action to what we expect … Continue reading →...
  • Direct Coupled On/Off Touch Switch
    The following touch switch circuit uses a CA3240 dual BiMOS op amp to sense small currents flowing between the contact points on a touch plate. Since this circuit is directly coupled with line voltage, a 1 M resistors in series … Continue reading →...
  • Remote On-Off Switch through Small Transformer
    This is a remote on-off switch circuit. With this circuit, we can take the benefit of using small switch to control larger AC current from high power devices. Safer operation is the other benefit, since this circuit is control the … Continue reading →...
  • FET Switch: A Voltage-Controlled Analog Switch
    This is a JFET switch circuit.This circuit uses a MPF102 JFET transistor. In this circuit, the JFET is symmetrical, so the input can be source or drain. The MPF102 is used because this transistor has gate’s reverse breakdown voltage of … Continue reading →...
  • Touch-Controlled Lamp Dimmer
    This is a three-modes lamp dimmer circuit with touch control. This circuit can be used to control a lamp in 3 operation modes: dim, off, and bright. A NE555 timer is used to generate a one-second pulse when we touch … Continue reading →...

Comments are closed.