Multiplexed BCD Decoder 7 Segments Driver

To save the complexity of driver circuit, a multiplexer icrcuit can be used for the solution. With this multiplexed BCD decoder, we can use only one BCD decoder to drive 3-digits 7 segment display. Each digit will be activated in sequence, but it will look like that all digits are driven continuously since the sequence is repeated quickly. Here is the schematic diagram of the circuit:

MULTIPLEXED BCD DECODER DRIVER CIRCUIT circuit schematic diagram

This entry was posted in Lighting and LED Circuit and tagged , . Bookmark the permalink.,
Possibly Related to "Multiplexed BCD Decoder 7 Segments Driver" Circuits

  • Brightness Control for Multiplexed LEDs
    To add PWM intensity control to connected LEDs, a switched-LED power supply approach can also be used. A circuit using a PWM-based supply to provide additional intensity control to some LEDs is shown on figure below. The PWM waveform and … Continue reading →...
  • Dual-Tone (Frequency) Decoder (Detector)
    The output of this circuit will be activated when a mix of two tone/frequency is detected on the input. The frequency f is determined by the values of R1 and C1, where f=1/(1.1 * R1 * C1). For security, using … Continue reading →...
  • LM 567 IC Touch-Tone Decoder
    This touch tone decoder can be used to decode a DTMF (Dual Tone Multiple Frequency) signal from a telephone device or from other generator. Using the frequency values shown in the schematic diagram, this circuit decodes a standard touch tone … Continue reading →...
  • TPS61059 White LED Driver for Photoflash or Movie Light
    Manufacturers are starting to turn to new high power to provide a photoflash function for these low-light conditions called white-light LEDs. These LEDs output is a wide light spectrum and it’s compact and easy to control. Unlike Xenon gas-discharges tubes … Continue reading →...
  • High-Brightness LED-Driver
    This is a high-brightness LED-driver circuit. To provide a constant-voltage output we usually use DC/DC regulators. But constant-current output is the one that is needed in LED application. To provide a constant-current output, we can use this circuit. Here is … Continue reading →...

Comments are closed.