Free Simple Circuit Diagram
The figure below show us a zener regulator. The essential component is the dropping resistor R which the value given by (V-Vo)/I, where I is the desired output plus 10%. As long as the supply voltage V is constant, the current in thner current drops to zero, and we is resistor is constant and is shared between the Zener and […]
Read more
This DC to AC Inverter uses inverter gates for the oscillator part, then use one of the gate to invert the produced square wave signal. With push pull operation, the primary coil of the transformer is driven with alternate direction, with the help of H bridge of power transistors (MOSFET) 2SJ471 and 2SK2956. Using the transformer shown in the schematic […]
Read more
The LP3992 is Micropower CMOS Voltage Regulator with input range of 1.9 to 5.2V and can produce 1.5V output. This regulator suits for application that need an accurate output voltage with power from battery, low quiescent current, low noise and portable. The accurateness of this regulator is 1.5 ± 0.009V and this device has output current of 30mA. The LP3992 […]
Read more
Despite the popularity of single-supply ICs, a negative control voltage is still required by some applications. Modern, inverted R-2R ladder DAC and op amp is the solution for this purpose. This approach offers lower supply voltages, higher speed, and smaller packages when compared with older DACs containing standard R-2R ladders. An output swing from 0V to 2.5V is produced by […]
Read more