Magnetic Phono Cartridges Transistor RIAA Preamp

The following two-transistor circuit is a pre-amplifier circuit for magnetic phono cartridge, which is characterized by its frequency response defined by RIAA standard for phono recording. This pre amp circuit  has gain around 40 dB (midband) at 1 kHz. Here is the schematic diagram of the circuit:

TRANSISTOR RIAA PREAMP FOR MAGNETIC PHONE CARTRIDGES circuit schematic diagram

[Circuit’s schematic diagram source: seekic.com]

This entry was posted in Audio and Music and tagged . Bookmark the permalink.,
Possibly Related to "Magnetic Phono Cartridges Transistor RIAA Preamp" Circuits

  • Magnetic Phono Preamp Has Ultra Low Noise Figure
    This circuit is a ultra low noise magnetic phono preamp. This circuit uses an LM381/1A. This circuit also includes RIAA equalization. This circuit has ultra low noise. The DC voltage level at the output of this circuit is about 16.5V, … Continue reading →...
  • Magnetic-Pickup Phono Preamplifier
    This is a simple circuit of magnetic pickup phono preamplifier. A proper loading to a reluctance is provided by this circuit. Here is the circuit: The gain provided by this circuit is approximately 25dB at 1kHz (2.2mV input for 100mV … Continue reading →...
  • Phono Pre-Amplifier
    This circuit is a simple circuit that can be used to listening old vinyl discs from a well preserved collection. This circuit efficient for cheap moving-magnet cartridges. It can be used in connection with the audio power amplifiers shown in … Continue reading →...
  • Detector for Magnetic Transducer
    Magnetic transducer is usually found in pulse counting application, and we can use this circuit to amplify and convert the signal from the transducer.  Here is the schematic diagram of the signal conditioning circuit: [Source: National Semiconductor Application Note]...
  • JFET Low Noise Preamp
    Noise, in amplifier circuit, is generated intrinsically by each components inside the circuit. Resistor, capacitor, and semiconductor generate noises. By simplifying the design of a circuit, we can minimize the noise especially if we can push the number of components … Continue reading →...

Comments are closed.