TDA8932B/33(B) Class D Audio Amplifier in Single Supply Single Ended Configuration

The following circuit diagram is a simplified application circuit of the TDA8932B/33(B) device when operated from an asymmetrical supply (single supply). Here’s the circuit diagram:

TDA8932B 33B Class D Audio Amplifier in Single Supply Single Ended Configuration circuit schematic diagram

To simplify the design for an asymmetrical supply in SE configuration, the TDA8932B/33(B) is equipped with three integrated half supply voltages buffers. The first buffer is for the reference decoupling capacitor (Chvpref) on HVPREF (pin 11) and the rest (two other buffers) are for the two AC-couple capacitors (Cse) in series with the speaker. [Source: NXP Application Note]

This entry was posted in Audio and Music and tagged . Bookmark the permalink.,
Possibly Related to "TDA8932B/33(B) Class D Audio Amplifier in Single Supply Single Ended Configuration" Circuits

  • TDA8932B/33(B) Class D Audio Amplifier in Symmetric Supply Single Ended Configuration
    We can also operate TDA8932B/33(B) from a symmetrical supply. On this diagram, three half supply voltage buffers are disabled. When supplied from a symmetrical supply, HVPREF (Pin 11), HVP1 (pin 30) and HVP2 (Pin 19) should be connected to ground. … Continue reading →...
  • Single Supply Summing Amplifier for Audio Mixer
    The basis of an audio mixer is an inverting summing circuit below. For real audio mixers, a single-supply voltage is seldom used. To increase dynamic range, the designer will often push an op amp up to, and sometimes beyond it’s … Continue reading →...
  • LM1875 20 Watt Audio Power Amplifier
    With LM1875, we can build a low cost but high performance audio power amplifier. With 50V power supply, it can produce 20W output power for 4 or 8 ohm speaker. We can even get 30W output if we use 60V … Continue reading →...
  • PWM Motor Speed Control Using Class D Audio Amplifier
    This is class D audio amplifier circuit that is used to control PWM motor speed. This circuit has two advantages for battery-powered portable devices. First, this circuit produces much less power dissipation than do it’s linear cousins. Second, it enhances … Continue reading →...
  • Small Discrete Audio Power Amplifier
    This is a little audio amplifier, it is similar to the audio amplifier which is used in small transistor radio. This circuit draws about 30 milliamps from a 9 volt supply. This circuit consist of two stage. First stage is … Continue reading →...

Comments are closed.