DC to AC Inverter

DC to AC inverter is used to convert DC voltage source to an AC voltage source. DC AC inverter circuit works by switching the DC voltage source to make an alternating current  that flow to a transformer. Here is an example of  dc ac inverter schematic:

dc to ac inverter 12v to 110v 220v circuit schematic diagram

This power inverter could generate 120 Watts power. A 15 fuse (as seen in the circuit diagram) must be installed since the dc-ac inverter will surge large amount of current if the oscillator fails.  This 12v dc to ac inverter could generate 110v or 220 volts AC voltage from your car’s battery to power many appliances.  This dc to ac inverter circuit generate squarewave output, and it can power resistive load like a soldering iron, incandescent bulbs, or some brushed AC motors. Some people has reported that they has succesfully use square wave dc ac inverter to powe their audio system,  even their laptop, but you must use on your own risk.  Finally, this 12v ac inverter has good efficiency, around 90% for various load power consumption. The drawback is that you need 10A transformer for this 12v 110v/220v inverter,  means that this device won’t be small, lightweight, or cheap.

This entry was posted in Power Supply and tagged . Bookmark the permalink.,
Possibly Related to "DC to AC Inverter" Circuits

  • Push-Pull Squarewave DC-to-AC Inverter
    This DC to AC Inverter uses inverter gates for the oscillator part, then use one of the gate to invert the produced square wave signal. With push pull operation, the primary coil of the transformer is driven with alternate direction, … Continue reading →...
  • High Voltage Inverter
    This is a simple high voltage inverter circuit. It is uses NPN transistor type 2N3055. This circuit used to invert low voltage to high voltage. Besides that, this circuit uses flyback transformer that can obtained from B/W or color TV … Continue reading →...
  • Self Powered Sine Wave to Square Converter
    Only with a single chip active component (4069 IC), this circuit will convert sine to square waves without a power-source. To test some audio instruments, we can use this circuit. Device purpose: This circuit intended to pick up the a … Continue reading →...
  • Super Simple Inverter
    This is example of a simple inverter that can be used to power fluorescent lamp and a small strobe. This circuit will produce over 400VDC from a 12 VDC, 2.5 A power supply or marine battery or an auto. This … Continue reading →...
  • 12V 6-12 Watt Fluorescent Tube (Neon) Lamp Inverter
    A 40 watt fluorescent tube lamp or two 20-watt tubes in series will be driven by this circuit but this circuit will produce less brightness than usual, since this circuit only deliver 6-12 Watts. This circuit draws 0.9-1.2 Amps for … Continue reading →...

Comments are closed.