Magnetic Phono Preamp Has Ultra Low Noise Figure

This circuit is a ultra low noise magnetic phono preamp. This circuit uses an LM381/1A. This circuit also includes RIAA equalization. This circuit has ultra low noise. The DC voltage level at the output of this circuit is about 16.5V, the voltage must be equal to half of the supply voltage. That can be done by adjusting potentiometer R7. Here is the schematic diagram of the circuit:

Ultra Low Noise Magnetic Phono Preamp circuit schematic diagram

This entry was posted in Audio and Music and tagged . Bookmark the permalink.,
Possibly Related to "Magnetic Phono Preamp Has Ultra Low Noise Figure" Circuits

  • Magnetic Phono Cartridges Transistor RIAA Preamp
    The following two-transistor circuit is a pre-amplifier circuit for magnetic phono cartridge, which is characterized by its frequency response defined by RIAA standard for phono recording. This pre amp circuitĀ  has gain around 40 dB (midband) at 1 kHz. Here … Continue reading →...
  • JFET Low Noise Preamp
    Noise, in amplifier circuit, is generated intrinsically by each components inside the circuit. Resistor, capacitor, and semiconductor generate noises. By simplifying the design of a circuit, we can minimize the noise especially if we can push the number of components … Continue reading →...
  • Philip’s Dynamic Noise Limiter
    When there is quiet passages, a tape noise becomes disturb. This noise can be reduces using Philips’ Dynamic Noise Limiter circuit. The principle operation of this circuit is improve the signal-to-noise ratio during the quite periods by decreasing the gain … Continue reading →...
  • Low Noise Power Supply for Audio Circuits
    This low noise audio power supply circuit can reduces noise and ripple voltage by 40dB over the 100Hz to 20kHz audio range. In portable application such as cellular phones and multimedia notebook computers, a clean source of 5V power for … Continue reading →...
  • Magnetic-Pickup Phono Preamplifier
    This is a simple circuit of magnetic pickup phono preamplifier. A proper loading to a reluctance is provided by this circuit. Here is the circuit: The gain provided by this circuit is approximately 25dB at 1kHz (2.2mV input for 100mV … Continue reading →...

Comments are closed.